
SoundBridge: Send Text Messages Over Any Radio
When the power, cell service and internet go down, voice still gets through. However, written messages are slow to pass by voice, and they are easy to copy wrong. That is why we built SoundBridge, a free way to send text messages over ham radio using only your phone. It turns any phone and any radio into a digital message station in seconds. First, you type a message. Then you hold your phone up to your radio’s microphone, and the other station’s phone turns the tones back into the exact words you typed. You need no cables, no software and no settings. Best of all, it is free, and it works with ham handhelds, mobile radios and base stations.
How It Works
SoundBridge sends your message as a fast series of musical tones. It uses 16 different pitches between about 1,000 and 2,500 hertz, right in the middle of what any voice radio can carry, and each tone carries four bits of your message. In other words, SoundBridge sends text messages over ham radio the same way a modem once sent data over a phone line. In addition, SoundBridge splits the message into small numbered parts, and every part carries its own error check. As a result, the receiving phone knows instantly when static damages a part, and it tells you exactly which parts to ask for again. Because of this, it will never show you half a message or a wrong word.
- Nine ready-made forms: plain message, ICS-213 General Message, ARRL Radiogram (with automatic check count), ICS-205 Radio Communications Plan, ICS-214 Activity Log, shelter status report, damage report, an “I’m OK” welfare message, and a Spanish “Estoy bien” welfare message.
- Automatic “got it” and resend: when a message arrives, the receiving phone answers with a short reply. If every part arrived, the sender sees “Confirmed.” If parts are missing, the sender’s phone hears which ones and resends just those, with no typing. Both operators simply press their talk button when the screen says KEY NOW, or use VOX.
- Net Control board: a big-screen dashboard shows every message with its status, flags high-priority traffic in red, and prints a finished ICS-309 Communications Log for the after-action report.
- Map of reports: damage, shelter and welfare reports can carry the sender’s GPS location, so net control sees them as pins on a map. Even without internet, the list of locations still works.
- Courier mode: any message can become a QR code. Then a volunteer scans it, carries it, and delivers it by text or email in one tap once they have a signal again.
- Message log: your phone saves every message you send, receive or carry, along with the time. Later, you can print it or download it for the after-action report.
- Works offline: open this page once while you have internet, and your phone keeps a copy. That way, it still opens when the internet is down. For best results, also add it to your home screen.
- Private: your messages, call sign and log stay on your phone. Likewise, SoundBridge handles microphone audio only on your phone and never records or uploads it.
Try It Today in Two Minutes
- First, open this page on two phones, or on a phone and a computer.
- Next, on the first phone, type your call sign and a short practice message.
- Then, on the second phone, open the Receive tab and press Start listening.
- Now hold the two phones a few inches apart and press Send by radio on the first one. You don’t even need a radio for this test!
- Finally, once that works, try it with two radios on a simplex frequency, and then practice on your club’s weekly net. Our Emergency Comms Dashboard lists local AUXCOMM frequencies and nets.
Tips for Clean Copy
- Hold the sending phone 1 to 2 inches from the radio’s microphone, with the phone volume at about three quarters. However, too much volume can distort the tones.
- On the receiving end, set the radio volume to about half and keep the phone close to the speaker. Also, a quiet room helps.
- If you go through a repeater or use VOX, choose the Long lead-in tone in Settings. That way, the repeater has time to key up.
- Keep messages short and to the point. For example, a typical message takes 15 to 40 seconds.
- Above all, practice before you need it. In fact, your club can add a SoundBridge test to its weekly net.
The Rules: Using SoundBridge on Amateur Radio
- No secret codes. SoundBridge does not encrypt anything. In fact, FCC rule 97.113 does not allow anyone to encode amateur messages to hide their meaning, so anyone running SoundBridge can read what you send.
- Identify your station. SoundBridge puts your call sign in every message automatically. Even so, you still need to identify by voice or another normal method at least every 10 minutes and at the end of your contact, as FCC rule 97.119 requires.
- Pick the right frequency. Use frequencies where the band plan allows data. Also, ask a repeater owner before you send data through their repeater.
- Same rules as voice: everything you already follow for voice traffic still applies. For example, pass health or personal details only as your served agency directs.
Frequently Asked Questions
Do I need any special equipment?
No. You only need a phone with a web browser and a radio. SoundBridge works through the air, from your phone’s speaker into the radio’s microphone, and then from the radio’s speaker into the other phone’s microphone.
Does it work on iPhone and Android?
Yes. It works in Safari on iPhone and in Chrome on Android, as well as on laptops. However, the first time you receive, your phone will ask permission to use the microphone.
How fast is it?
About 12 characters per second. For example, a typical shelter status report takes 20 to 30 seconds. That is slower than an internet text. Even so, it is much faster and more accurate than reading a message aloud and copying it by hand.
What if static wipes out part of my message?
The receiving phone shows which parts it is missing, such as “parts 3 and 5.” Then the sender types those numbers in the Resend only some parts box, and SoundBridge sends only those parts again.
Can I use it with FRS or GMRS radios?
We designed SoundBridge for amateur radio. However, other radio services have their own rules about sending data, so check the rules for your radio service before you use it there.
SoundBridge is a free tool from the Atlantic Coast United Radio Association (ACURA). Remember, it is a practice and backup tool for sending text messages over ham radio, so it does not replace your served agency’s official procedures. Want to see how your local network would hold up in a long blackout? Try Last Link Standing.
